Scenes BJ Fantasy

I figured out that there was a subscene which was linking to an old version of the scene back when I was a noob and it was causing all sorts of dependencies. Those responsible have been sacked.

I reworked every keyframe of animation to optimize the movement for ToySerialController v17. I have switched to using ToySerialController v17 by @Yoooi, and I have made a preset that works great for blowjobs. It's called "BMSM13" and you can get it for free on my Patreon:

https://www.patreon.com/posts/toyserialcontrol-75073547?utm_medium=clipboard_copy&utm_source=copyLink&utm_campaign=postshare_creator&utm_content=join_link

I also added an "alignment wafer" to toggle on and off that goes right between the girls lips at the start position. The toggle switch is to the right of the guy. If you load a model and the wafer is not right between their lips, the animations will not line up. You should reposition your preferred model and then save the Pose Preset to include the Root. You can make adjustments to your model's pose and save another Pose Preset until the animations work, but many models work well without changing their position. I added a "petite model" pose toggle since I found that the petite models were the trickiest to get right, and there is a Standard model pose toggle to get back to the original position if needed.

I added an edging voice command, "I'm close" which will stop the girl for 11 seconds, and there is a button for that, too.

I changed/added the voice commands "slower" and "faster" to enable finer control of the BJ animation speed. Tried this scene out now that I have an onahole with a tongue and oh my god! You need this in your life.
I changed two of the old commands from "slower" to "mellow" and from "faster" to "sexy". Those commands set the speed to predetermined values instead of incrementing up or down.

Because I am so good at this, I have corrected another error that my army of code minions did not catch. Those responsible have been sacked.

I found a syntax error in the dependencies list that prevented them from loading. There are a lot of dependencies that are hub hosted. Ignore the ones that aren't on the hub. Also, it takes a few restarts, rescans and reloads to get all of the dependencies and the voice commands working. I don't know why, but stick with it because it's awesome when it works.

I tried my best to trim the dependencies list. I also reset the recorded limits for the Tcode Serial Controller and applied new ones which, and least on my SR6, greatly enhanced the twist axis moves.